Enables fast metal drilling due to the PointTeQ design on the drill bit. Quick and easy tapping is possible because the self-centering tip prevents walking and due to the increased drilling rate, heat and wear are reduced. The PointTeQ design on the drill bit remains sharp and withstands continuous use, suitable for drilling through and center holes in alloyed and unalloyed steel, in non-ferrous metals, cast steel, cast iron and plastic. The shaft is cylindrical, the shank is equal to the diameter of the drill and is intended for drill presses and drill drivers, with a low risk of breakage, especially for drills with a diameter less than 6mm, as the drill has been made to have a highly elastic body. The black oxide coated groove allows quick removal of the chips, manufactured according to DIN 338, drill type N (small side rake angle) with a point angle of 135°. Set contains sizes; 2.0/3.0/4.0/5.0/6.0mm